Is there a way to pull out the Psets from the QX tool using the QCX controller? Can I modify a Pset on a tool that is paired to the QCX controller via USB?
All users of the QCX controller.
The controller is the "owner" of settings when a tool is paired to the controller. Tool settings will not be copied from the QX tool to the controller.
The user must create Psets and then assign them to jobs. When pairing a tool, the Psets and general settings saved on the controller are applied to the paired tool. Anything already on the tool is not valid. In this way, if a tool goes down, the user only needs to pair a spare tool and all the settings are applied to the new tool and the line can be back up and running in a short amount of time.
The user cannot connect a tool via USB and save the Psets from the tool to the controller to be assigned later to jobs.