[TSB] RI2019-001 2135QTL-2 – New Tool Installation Procedure (rev. 01)

Subject:

2135QTL-2 – New Tool Installation Procedure

Affected Products:   

2135QTL-2

Affected Date Range:   

All

Related Issue #:   

#1727965

Issue Description:

This TSB describes the installation process.

Actions Required:

When placing the new 2135QTL-2 torque limited impact wrench into service, the following steps must be performed:

• Add approximately 1/4 teaspoon (~1 cc) of Air Tool Oil directly into the tool air inlet prior to use.
  • Running a new tool without oil can lead to irregular performance and decreased power.
  • 4-5 drops of air tool oil should be added to the tool inlet daily for best performance and durability.
•  Air pressure must be set to 90 psi dynamic (measured at the tool air inlet with the tool running at free speed in reverse).
  • Due to the method of torque limitation used in the new 2135QTL-2, this is especially important. Air pressures significantly lower than 90 psi dynamic will decrease torque output and free speed, and reduce efficiency.
  • The 2135QTL-2 is designed to run with 90 psi of dynamic air pressure -- All performance and durability testing was performed at this pressure.
  • See video linked below for demonstration of setting dynamic air pressure.
    • https://youtu.be/Cb4MEodi1MY

For Additional Information and assistance:
 

Browse the Knowledge Base:  https://irtoolhelp.ingersollrand.com

Submit a Request for assistance

Technical Support:  Contact Ingersoll Rand Technical Support at irtechsupport@irco.com.

Warranty Support:  Contact the Warranty Department at TFM_Warranty@irco.com .

 Phone:  800-483-4981 or 800-866-5457

Distribution:

Document Revision History: