Terms, Defaults, & Recommended Settings for YS-e

Yokota Term

Meaning

IR Comparable Term

(if applicable)

Default Value

General Quick Setup Recommendations

Start TRQ

The torque which the tool will start judging the result of rundown, cycle start

Torque Threshold

3

1/3 of Target Torque, around seating point

Switch TRQ

The torque which switches the motor speed from Middle Speed to High Speed

Shiftdown Point

3

Min TRQ

If the torque does not reach this value after pulsing the number of SLOW Err value,
the tool would judge as "Min Torque NOK"

Low Torque Limit

3

Cut TRQ

Target torque. The tool will shut off after the displayed torque has exceeded.

Target Torque

3

Max TRQ

If the displayed torque exceeds this value,
the tool would judge as "Over Torque NOK"

High Torque Limit

3

Free Ang Min

Minimum shaft rotating angle before reaching Start Torque. (Before bolt is seated)

n/a

0

Free Ang Max

Maximum shaft rotating angle before reaching Start Torque. (After bolt is seated)

n/a

30000

Final Ang Min

Minimum shaft rotating angle after reaching Start Torque. (After bolt is seated)

Low Angle Limit

0

For ‘re-hit’ detection, set to 50 degrees

Final Ang Max

Maximum shaft rotating angle after reaching Start Torque. (After bolt is seated)

High Angle Limit

9999

Free abort Time

The count of the free running angle will be reset to "0", when the shaft has not been rotated for the set valued time

n/a

0.10

Low Speed

Motor speed when the trigger is half-pulled, feathered

n/a

1200

1200 ~ 1500

Mid Speed

Motor speed before reaching SWITCH TORQUE, when trigger is fully engaged

Free Speed

2000

1500 ~ 3000

High Speed

Motor speed after reaching SWITCH TORQUE

Shiftdown Speed

3000

1500 ~ 4800, should use speed that produces consistent torque results

Bolt Co-Eff

This function is to recalculate the displayed torque if there is a great difference from the actual torque.

TR Value (similar)

1.00

1.00 = 100%; Ex) if you want the displayed torque value to increase by 20%, change this value to ‘1.2’

Average No

The number of pulses that the system should average the measured torque values of and use as the display torque

n/a

3

Skip No

The number of initial pulses the tool will skip and not measure after reaching the start torque.

n/a

2

Slow Er No

When the number of pulses in a tightening exceed this value and the tool has not yet measured torque > than the MIN TRQ value, the tool will stop and display this error.  The tool is getting to torque too slow, hence – SLOW ERROR

n/a

20

Compen No

The number of pulses preset as compensation pulses, which will be performed after the display torque exceeds the cut torque, and the motor will be automatically stopped.

0

Max Pulse

Maximum number of pulse after reaching start torque. If the pulse exceeds while fastening, the tool will judge as "Over Pulse NOK"

30

Min Pulse

Minimum number of pulse required before the tool shuts off. If the torque reaches before the set number of pulse, the tool will judge as "Min, Pulse NOK"

2